After you get familiar to AutoCAD interface and it’s navigation tools, now it’s time for you to learn how to use drawing tools. I know a lot of instructor showing the students how to use each drawing tools. But then a couple of weeks after finishing their training, the students struggle to remember how using them.
Drawing tools should be very easy. Each of the tools name describe what they do. Line tool will draw a line, rectangle tool will draw rectangle. Easy, right? What you have to understand is, every tool might have different way to be used. It’s difficult to remember all of the steps in each tool. That’s what command line is for (or you can use dynamic input).
Command line is just like a road sign, it will guide you so you don’t get lost. Try to activate a drawing tool, like a line.
Command: _line Specify first point:
Specify next point or [Undo]:
Specify next point or [Undo]:
Specify next point or [Close/Undo]:
After you activate the line tool, then AutoCAD will tell you what to do: specify first point. Define your point by clicking in the drawing area, then it will ask you again: specify next point. Just click any where in your drawing area, don’t worry about the size or precise coordinate yet.
Now let’s try for circle:
Command: ARC Specify start point of arc or [Center]: C
Specify center point of arc:
Specify start point of arc:
Specify end point of arc or [Angle/chord Length]:
After I activate circle, AutoCAD will tell me to specify a start point, and give an option: I can switch from specifying a start point to a center point. This time, I type the capital letter in the option, C, to switch to specify center point. Then AutoCAD ask me for center point, start point, then end point consecutively.
Follow command line, then you should be OK. Even for you who have used AutoCAD for years, you should be watching command line sometimes. Especially when you use a new version, try to find if there is any new option there.
No comments:
Post a Comment